Adjust the legs until the washer is level.
Then, turn the leg clockwise to lower the leg or counterclockwise to raise the leg. To adjust the leveling legs, locate the locking nut on the leg and loosen it with a wrench. Most washers come with four leveling legs at the base of the washer. If the drum is leaning more to one side, you will need to adjust the legs to raise the side that the drum is leaning toward. On top-loader washers, you can check that the plastic guard around the drum is not more exposed on one side than the other. If the washer is not level, adjust the legs on the washer to fix the issue. Check with the level positioned front to back and across the width, side to side. Use a bubble level to ensure that the washer is level. Checking that the washer is level can also ensure the issue does not happen again.
#Whirlpool gas range hall sensor location code#
If the code is no longer showing, make sure not to overload the washer and balance out future loads. If the code is showing, move on to the next solution to troubleshoot the issue. At the end of the cycle, check if the uE or UE error code is still showing. Run a Rinse and Spin CycleĮmpty the washer then run a rinse and spin cycle. If you have a top-loader washer, check that items are not tangled up around the agitator and causing the issue. Consider adjusting the wash cycle’s settings or add or remove items to fix the issue. Often, bulky or large items, like pillows and blankets, or sometimes small loads, can cause the washer to be off-balance. If the load appears unbalanced, consider adding or removing items to balance it out. Make Sure the Load is BalancedĬheck that the washer is not overloaded and remove items if necessary. If it cannot resolve the issue, the error code will switch from uE to UE, which means that the washer cannot balance the load and the issue requires assistance.įollow the solutions below to fix the issue and clear the UE error code.
The washer should repeat this process three times. It will then drain and try to spin again. The washer will fill with water to try to balance the load. When the uE error code is displayed, it means that the washer is trying to resolve the issue. However, if the error persists, it may mean that there is a faulty part that needs to be replaced. In most cases, the issue can be fixed by adjusting the load or by leveling the washer. An LG washer displaying the UE or uE error code means that the load in the washer is unbalanced.
0 kommentar(er)
